Skip to main content
Use this if DP360 is your CRM. If your CRM takes standard ADF/XML by email without a special subject prefix, use generic ADF instead. DP360 expects leads by email with a specific subject-line prefix so it can route them to the right tenant. That is the only meaningful difference from generic ADF.

​
Set it up

1

Open the DP360 sub-page

Resource settings → Integrations → CRM → DP360.
2

Enter your vendor ID

The identifier DP360 gave your dealership. Required. It becomes the email subject prefix DP360 uses for tenant routing.
3

Add destinations

Click Add destination and enter the address DP360 leads should go to. Add more if several addresses should receive each lead.
4

Save

Ekho starts sending ADF/XML prefixed with your vendor ID on the next qualifying lead.
A wrong or missing vendor ID means DP360 receives the email but cannot route it, so leads silently fail to appear. If leads are not showing up, check this first.

​
Update or remove

  • Update — return to the DP360 sub-page, edit the vendor ID or destinations, and save.
  • Remove — click Remove. Other configured vendors keep receiving leads.